PROBLEM:How to set inform on UniFi AP in CLI or Command?
How to maually point UniFi AP to UniFi Controller?
SOLUTION:
1.) make sure the AP is running the latest (or 2.1.0+)
- if it's not, do
- syswrapper.sh upgrade http://ip-of-controller:8080/dl/firmware/BZ2/version-of-ap-see-ref-table-below/firmware.bin
2.) make sure the AP is in factory default state
- if it's not, do
- syswrapper.sh restore-default
3.) ssh into the device and type
- mca-cli
- the CLI interface: set-inform http://ip-of-controller:8080/inform