Manually set UAB AP to point to UniFi Controller

[Adventech]

PROBLEM:
How to set inform on UniFi AP in CLI or Command?
How to maually point UniFi AP to UniFi Controller?

SOLUTION:

1.) make sure the AP is running the latest (or 2.1.0+)

• if it's not, do
• syswrapper.sh upgrade http://ip-of-controller:8080/dl/firmware/BZ2/version-of-ap-see-ref-table-below/firmware.bin
2.) make sure the AP is in factory default state

• if it's not, do
• syswrapper.sh restore-default
3.) ssh into the device and type

• mca-cli
• the CLI interface: set-inform http://ip-of-controller:8080/inform